Create Service Provider To Connect Two Ip Pbxes; Create Service Provider - ATCOM IPPBX IP04 User Manual

IPPBX IP04 User Manual

5. Create Service Provider to connect two IP PBXes

Service Provider is used to interconnect two IP PBXes, it must be created in both IP PBXes, after setting service
provider and outbound route, extensions of each IP PBX can call the other's directly according to the outbound
route.

Create Service Provider

5.1
Go to PBX Settings -> Trunks, Click to add a new service provider.
Type
Trunk type: SIP,IAX
Provider Hostname/IP
Hostname or IP of your VoIP provider, SIP Trunk default port is 5060 and IAX Trunk default is 4569.
Provider Name
A unique label to help you identify the service provider.
Call Recording
Check this option to record all calls made by this trunk. User can check the recordings with record
account(password is the same with admin) .
Maximum Outbound Calls
Define the maximum quantity of outbound connections (simultaneous calls) that can be used on this trunk.
Inbound calls are not counted in. 0 means no connection limit.
Transport
The transplant protocol type for VoIP data package, default is UDP. Please make sure TCP is enabled in PBX
Settings -> SIP Settings before using TCP.
Preferred Code
Set the allowed codec and priority for this trunk.
Advance Configuration
DOD(Direct Outward Dialing Number) Setting
Set the Outbound number for different extensions. Detailed example can be found in Chapter 4.1.
~ 28 ~
ATCOM TECHNOLOGY CO., LIMITED