SECTION 13—RECLINER BACK OPTION
Squeeze Trigger Release Lever To
Align Mounting Holes (STEP 7, 8)
Actuator
Housing
Washer
(STEPS 2, 9)
Jam Nut (STEPS 1, 4, 6)
Locknut
(STEPS 2,9)
Cylinder Rod
Nylon Washer (STEPS 2, 9)
Gas Cylinder
Button Head Cap
Screw (STEPS 2, 9)
Bracket
Spacer (STEPS 2, 9)
FIGURE 13.4 Replacing the Gas Cylinders
Adjusting the Gas Cylinders
WARNING
Both gas cylinders MUST be operational and adjusted properly BEFORE using the
recliner. DO NOT operate the recliner if only one of the gas cylinders is
operational or adjusted properly.
NOTE: For this procedure, refer to FIGURE 13.5 on page 85.
Determining Necessary Adjustments
NOTE: The gas cylinders are controlled by the trigger release levers mounted on the opposite sides
of the gas cylinders. The right trigger release lever controls the left gas cylinder, and the left trigger
release lever controls the right gas cylinder.
Refer to the following chart to determine the necessary adjustments:
83
®
™
Part No 1125027
Solara
/Spree GT