Operation Information - Invacare Solara Spree GT Owner's Operator And Maintenance Manual

SECTION 1—GENERAL GUIDELINES
ALWAYS engage both wheel locks while reclining or inclining (sitting up) the wheelchair.
Both gas cylinders MUST be operational and adjusted properly before using the recliner.
DO NOT operate the recliner option if only one of the gas cylinders is operational or
adjusted properly.
Make sure the patient is properly positioned in the wheelchair before reclining or
inclining (sitting up) to maintain maximum stability and safety.
When returning the occupant of the wheelchair to the full upright position, more body
strength will be required for approximately the last twenty degrees of incline (sitting up).
Make sure to use proper body mechanics (use your legs) or seek assistance to avoid injury.
ALWAYS return the back to the upright position before lifting the wheelchair.

Operation Information

Unless otherwise noted, all service and adjustments should be performed while the
wheelchair is unoccupied.
To determine and establish your particular safety limits, practice bending, reaching and
transferring activities in the presence of a qualified healthcare professional before
attempting active use of the wheelchair.
ALWAYS wear your seat positioning strap. The seat positioning strap is a positioning belt
only. It is not designed for use as a safety device withstanding high stress loads such as
auto or aircraft safety belts. If signs of wear appear, belt MUST be replaced
IMMEDIATELY.
If the wheelchair is exposed to extreme temperature (above 100°F or below 32°F), high
humidity and/or becomes wet, prior to use, ensure handgrips DO NOT twist on the
wheelchair handle - otherwise damage or injury may occur.
ALWAYS check foam grips for looseness before using the wheelchair. If loose, contact a
qualified technician for instructions.
The necessary back angle (90°, 100°, 110° or 120°) MUST be selected before repositioning
the rear wheels forward.
DO NOT operate the tilt-in-space if the trigger release levers and cables are not properly
adjusted to ensure that the tilt-in-space is locked in place when engaged.
Pinch point may occur when returning the tilted seat to the full upright position. Make
sure the hands and body of the occupant, attendants and bystanders are clear of all pinch
points before returning the tilted seat to the full upright position.
DO NOT traverse, climb or go down ramps or slopes greater than 9°.
NEVER leave the occupied wheelchair unattended at any time, especially on an incline.
DO NOT attempt to reach objects if you have to move forward in the seat.
DO NOT attempt to reach objects if you have to pick them up from the floor by reaching
down between your knees.
17 ® ™
Part No 1125027 Solara /Spree GT