Angle Adjustment; Installing/Removing Elevating Legrests; Installing; Removing - Invacare Solara Spree GT Owner's Operator And Maintenance Manual

NOTE: The setting for positioning the footplate on the half clamp may vary for each footplate.
4. Repeat STEPS 1-3 for opposite footplate, if desired.

Angle Adjustment

1. Loosen, but DO NOT remove the adjustment screw in the half clamp.
2. Position the footplate to the necessary angle to accommodate the user (Detail "A").
3. Retighten the adjustment screw. Torque to over 90 in-lbs, but no more than 300 in-lbs.
4. Repeat STEPS 1-3 for opposite footplate, if desired.
5. Screw in or out until the adjustable angle flip-up footplate is perpendicular to the
footrest assembly or the desired inversion/eversion is obtained.
90° Footrest Support
Flat Screws
Footplate
Half Clamp
Adjustment Screw
FIGURE 6.6 Adjusting Adjustable Angle Flip-Up Footplates

Installing/Removing Elevating Legrests

NOTE: For this procedure, refer to FIGURE 6.7 on page 38.

Installing

1. Place elevating legrest on the outside of the wheelchair and insert mounting pin into
the mounting tube.
2. Rotate elevating legrest toward the inside of the wheelchair until it locks in place.
NOTE: The calfpad of the legrest will be on the inside of the wheelchair when locked in place.
3. Repeat STEPS 1-3 for the other elevating legrest assembly.

Removing

1. Push the legrest release handle inward while rotating the elevating legrest outward.
2. Lift the legrest assembly out of the mounting tube of the wheelchair frame.
3. Repeat STEPS 1-2 for opposite side, if necessary.
Part No 1125027
Detail "A" - Side View of Footplate and Footrest
Footplate
Footplate
Hinge
Locknuts
37
SECTION 6—FRONT RIGGINGS
Support
Footrest Support
Solara
® ™
/Spree GT