Displayed Messages; Empty Grounds Container - DeLonghi ESAM 04.320 Owner's Manual

DISPlAYED MESSAGES

DISPlAYED MESSAGE
FILL TANK!
grouNd Too FiNe adJuST
MILL!
Turn steam knob

eMPTy grouNdS CoNTaiNer

iNSerT grouNdS CoNTaiNer
add Pre-grouNd CoFFee
DESCALE!
LESS COFFEE!
FILL BEANS CONTAINER!
INSERT INFUSER ASSEMBLY!
CLOSE DOOR!
add Pre-grouNd CoFFee
add Pre-grouNd CoFFee
Press OK
energy Saving
GENERAL ALARM!
POSSIBlE CAUSE
Insufficient water in the tank.
The grinding is too fine and the coffee is delivered too
slowly or not at all.
The grounds container is too full or more than 3 days have
passed since you last made coffee (this guarantees correct
hygiene of the machine).
after cleaning, the grounds container has not been
replaced.
The "pre-ground coffee" function has been selected
without placing any pre-ground coffee in the funnel.
The machine must be descaled.
Too much coffee has been used.
The coffee beans have run out.
The pre-ground coffee funnel is clogged.
The infuser has not been replaced after cleaning.
The service door is open.
The "pre-ground coffee" function has been selected
without placing any pre-ground coffee in the funnel.
The funnel (a8) is blocked.
a loNg coffee of more than 125 ml has been made with
pre-ground coffee.
The function is active and reduces electricity consumption.
The inside of the appliance is very dirty.
18
REMEDY
Fill the tank with water and/or insert it correctly, pushing it
as far as it will go until it clicks into place.
When the steam knob has been turned to the i position
as requested by the appliance, press the OK button and
deliver water from the spout until the water flow is regular.
Stop the water flow and repeat coffee delivery, turning the
grinding adjustment knob one click clockwise towards "7"
while the coffee mill is in operation.
if after making at least 2 coffees delivery is still too slow,
repeat the correction procedure, turning the grinding
adjustment knob another click until delivery is correct.
empty the grounds container and clean, then replace.
important: when removing the drip tray, the grounds
container MuST be emptied, even if it contains few
grounds.
if this is not done, when you make the next coffees, the
grounds container may fill up more than expected and clog
the machine.
open the service door, remove the drip tray and insert the
grounds container.
Place pre-ground coffee in the funnel or deselect the
"pre-ground" function.
The descaling procedure described in the "descaling"
section needs to be performed as soon as possible.
Select a milder taste or reduce the quantity of pre-ground
coffee.
Fill the beans container
empty the funnel with the help of a knife, as described in
the section "Cleaning the pre-ground coffee funnel".
insert the infuser as described in the paragraph "Cleaning
the infuser".
Close the service door.
Place pre-ground coffee in the funnel.
empty the funnel with the help of a knife, as described in
the section "Cleaning the pre-ground coffee funnel".
Add pre-ground coffee and press OK.
disable the function from the menu (See section "energy
Saving").
Clean the inside of the appliance thoroughly, as described
in the section "Cleaning and maintenance". if the message
is still displayed after cleaning, contact a service centre.