Appendix 3: Faceplate And Decorative Trims Installation - Drolet Escape 1800 Insert Installation And Operation Manual

Escape 1800 Insert Installation and Operation Manual

Appendix 3: Faceplate and Decorative Trims Installation

Note: The illustrations may vary from one model to another, but the method of assembly
remains the same.
Remove the faceplate panels from its box and the faceplate extension secured between
the firebox and the convection air jacket.
Place the faceplate panels with the finished side down on a flat, soft, non-abrasive surface
and follow the installation instructions below;
Hardware bag content:
8 - #10-24" x 1/2" bolts
8 - Trim retainer
2 - Corner bracket and screws
8 - #10-24" hex nuts
Line up the holes of the upper faceplate
panel (A) with the holes of the side panels
(B) and (C). Secure them together using
four (4) bolts (D) and nuts (E) provided (see
DETAIL A).
Partially thread the screws (H) on the trim's
corner bracket (G) then superimpose the
corner brackets (F) and (G) as shown in the
image on the left.
51