Drolet Escape 1800 Insert Installation And Operation Manual page 53

Escape 1800 Insert Installation and Operation Manual
Then align the holes in the faceplate extension (M) with the holes in each faceplate side
panels and secure both assembly together using four (4) bolts (D) and nuts (E) provided
(see DETAIL C) .
Note: If the installation of a heat radiation shield is required to reduce clearances from the
shelf and upper surround, refer to Appendix 4: Top Surround and Shelf Heat Shield
Installation (AC01317) prior to the installation of the faceplate on the insert.
Center the insert into the fireplace
opening.
Align the notch in the faceplate
extension with the bolt (N) welded to
the air jacket located (see DETAIL D)
and slide the faceplate assembly just
over the bolt's head and washer (O).
Then push towards the fireplace.
If necessary, adjust the height of the
insert using the leveling bolts on each
side of the convection air jacket until
the faceplate is properly seated on the
floor of the hearth extension.
Once the faceplate is in place, secure
the assembly by tightening nut (P)
using a 7/16" (11mm) open end
wrench.
53