Faceplate And Decorative Trims Installation Instructions (Sold Separately) - Drolet Escape 1400-I Insert Owner's Manual

4. If lag-bolts and anchors are to be used to secure the insert, the hole locations should be marked
with the unit in place. Remove the insert and locate the anchors.
5. Remove the faceplate panels from their box and assemble according to the following
instructions.

2.4 Faceplate and decorative trims installation Instructions (sold separately)

Remove the faceplate panels from its box and the faceplate extension secured between the firebox and
the convection air jacket.
Place the faceplate panels with the finished side down on a flat, soft, non-abrasive surface and follow the
installation instructions below;
Hardware bag content:
8 - #10-24" x 1/2" bolts
8 - Trim retainer
2 - Corner bracket and screws
8 - #10-24" hex nuts
Line up the holes of the upper faceplate panel
(A) with the holes of the side panels (B) and
(C). Secure them together using four (4) bolts
(D) and nuts (E) provided (see DETAIL A).
Partially thread the screws (F) on the trim's
corner bracket (G) then superimpose the
corner brackets (G) and (H) as shown in the
image on the left.
11