Appendix 3: Optional Faceplate And Decorative Trims; Installation (Ac03350 / Ac03360) - Drolet Escape 1400 Installation And Operation Manual

Escape 1400 Insert Installation and Operation Manual
Appendix 3:

Installation (AC03350 / AC03360)

Note: The illustrations may vary from one model to another, but the method of assembly
remains the same.
Remove the faceplate panels from its box and the faceplate extension secured between
the firebox and the convection air jacket.
Place the faceplate panels with the finished side down on a flat, soft, non-abrasive surface
and follow the installation instructions below;
Hardware bag content:
8 - #10-24" x 1/2" bolts
8 - Trim retainer
Optional Faceplate
2 - Corner bracket and screws
8 - #10-24" hex nuts
and Decorative
Line up the holes of the upper faceplate
panel (A) with the holes of the side
panels (B) and (C). Secure them
together using four (4) bolts (D) and nuts
(E) provided.
Partially thread the screws (F) on the
trim's corner bracket
superimpose the corner brackets (G)
and (H) as shown in the image on the
left.
Trims
(G) then
47