Appendix 3: Optional Faceplate And Decorative Trims; Installation - Drolet Escape 1800-I Insert Installation And Operation Manual

Escape 1800-I Insert Installation and Operation Manual
Appendix 3:

Installation

Note: The illustrations may vary from one model to another, but the method of assembly
remains the same.
Remove the faceplate panels from its box and the faceplate extension secured between the
firebox and the convection air jacket.
Place the faceplate panels with the finished side down on a flat, soft, non-abrasive surface
and follow the installation instructions below;
Hardware bag content:
8 - #10-24" x 1/2" bolts
8 - Trim retainer
44
Optional Faceplate
2 - Corner bracket and screws
8 - #10-24" hex nuts
and Decorative
Line up the holes of the upper faceplate
panel (A) with the holes of the side panels
(B) and (C). Secure them together using
four (4) bolts (D) and nuts (E) provided (see
DETAIL A).
Partially thread the screws (H) on the trim's
corner bracket (G) then superimpose the
corner brackets (F) and (G) as shown in the
image on the left.
Trims