Table of Contents
Advertisement
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING:
WHAT TO DO IF YOU SMELL GAS
1.
STOP! Read the safety information above on this page.
2.
Push in gas control knob slightly and turn clockwise
to "OFF." Do not force.
3.
Wait ten (10) minutes to clear out any gas. Then smell for
"B" in the safety information above. If you do not smell gas,
go to the next step.
4.
Find pilot - the pilot is located in
front of the rear log.
5.
Turn manual gas control knob
counterclockwise
"PILOT."
6.
Push in manual gas control knob
all the way and hold in. Repeatedly push the piezo ignitor but-
ton until pilot is lit (or use a match to light). Continue to hold
the control knob in for about one (1) minute after the pilot is
1.
Push in gas control knob slightly and turn clockwise
to "OFF." Do not force.
Page 28
LIGHTING INSTRUCTIONS
to
TO TURN OFF GAS TO APPLIANCE
lit. Release knob and it will pop back up. Pilot should remain
lit. If it goes out, repeat steps 2 through 6.
mediately call your service technician or gas supplier
control knob to "OFF" and call your service technician or
gas supplier.
7.
Three heat settings can be selected by slightly depressing the
manual gas control knob and turning the manual gas control
knob counterclockwise
8.
CAUTION! When the manual gas control knob has been
turned to desired heat setting, ensure that the manual gas
control knob is locked into that heat setting and cannot be
turned without being depressed. If the manual gas control
knob is in mid-position, between heat settings, incomplete
combustion will take place, causing odor and may produce
gas leakage or carbon monoxide.
-
to 1, 2 or 3.
30726-0-0612
Hide quick links:
Advertisement
Table of Contents
