Table of Contents
Advertisement
Before you begin: if you are installing logs onto the VFD(R,T,M)18 or
VFD(R,T,M)24 models, this burner assembly is supplied with a set
hands! Always wear gloves to prevent skin irritation from ceramic
The positioning of the logs is critical to the safe and clean operation
of this burner assembly. Sooting and other problems may result if the
Refer to Figure 12 and corresponding warning when completing
following log placement instructions.
Failure to position the parts in accordance with this diagram or
may result in property damage or personal injury.
Attention: Do not use Figure 13 or Figure 14 to order logs. Refer
to Parts Lists and Parts Views to order logs and/or ember material
for your appropriate model.
E
B
D
30726-0-0612
WARNING
G
A
Figure 12
EMBER MATERIAL PLACEMENT ON BURNER
After all logs are positioned properly, apply Rockwool ember material
to the front burner port area. To apply, carefully separate the ember
material into small amounts no larger than "dime size" pieces.
Fluffed up pieces one layer thick on top of the burner generally
works best, and will provide the best ember glow. Do not place
ember material more than one layer thick. No more than (2) two
small packets of ember material (part no. 15998) evenly placed
on the burner, is recommended on VFDR18 and VFDR24 models.
Using additional ember material will decrease the amount of ember
glow effect. Extra ember material should be saved for future ember
applications as necessary.
F
Description
VFD(R,T,M)18 Embers
VFD(R,T,M)24 Embers
VFD(R,T,M)30 Embers
C
Platinum Bright Embers
NOTICE: A single layer of embers is to be used when applying
Platinum Bright Embers (alone or in combination with standard
embers) to the burner.
Figure 13
Part #
15998
15998
15999
PE20-1
Page 15
Hide quick links:
Advertisement
Table of Contents
