Table of Contents
Advertisement
Cleaning and Maintenance/Pilot
Depletion Sensor as follows:
1. Clean the ODS pilot by loosening nut B from the pilot tubing.
wrench.
2. Blow air pressure through the holes indicated by the arrows.
This will blow out foreign materials such as dust, lint and spider
webs. Tighten nut B also by grasping nut A.
service technician is recommended to prevent malfunction
TURN OFF HEATER AND ALLOW TO COOL BEFORE
Remove logs, handling carefully by holding gently at each end.
Gloves are recommended to prevent skin irritation from ceramic
Refer to manual for correct log placement.
PERIODIC CLEANING – Refer to parts diagram for location of
attachment.
grate.
with brush. Failure to keep air intake hole clean will result in
sooting and poor combustion.
Page 30
PILOT FLAME CHARACTERISTICS
CLEANING AND SERVICING
Figure 23 - VFDR
Figure 24 - VFDT & VFDM
ANNUAL CLEANING/INSPECTION – Refer to parts diagram for
with vacuum or brush. Failure to keep air intake hole clean will
result in sooting and poor combustion.
intake holes.
30726-0-0612
Hide quick links:
Advertisement
Table of Contents
