Vfse-(18,24,30) Lighting Instructions - Empire Comfort Systems VFSE-18-1 Installation Instructions And Owner's Manual

VFSE-(18,24,30) LIGHTING INSTRUCTIONS

FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion may
result causing property damage, personal injury or loss of life.
A. BEFORE LIGHTING smell all around the appliance
area for gas. Be sure to smell next to the floor because
some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch.
• Do not use any phone in your building.
• Immediately call your gas supplier from a neigh-
bor's phone. Follow the gas supplier's instructions.
• If you can not reach your gas supplier, call the fire
department.
1. STOP! Read the safety information above on this page.
2. Open bottom louver assembly, (if applicable).
3. Press the "I/O" (ON/OFF) button on the valve to face to "O"
(OFF).
4. Wait five (5) minutes to clear out any gas, then smell for
gas including near the floor. If you smell gas, STOP! Follow
"A" in the safety information above. If you don't smell gas,
go to the next step.
LIGHTING PROCEDURE - HANDSET METHOD
1. Turn control arrow on valve face to "ON." Press the "I/O"
button to "I". Press the "OFF" and "UP" buttons on the
handset firmly at the same time. A long "beep" will sound,
followed by 5 short "beeps". Ignitor will spark and will con-
tinue until pilot is lit. For full Remote Control operation see
appliance installation manual.
LIGHTING PROCEDURE - MANUAL METHOD
1. Press the "I/O" (ON/OFF) button to "I" for on.
2. Turn control arrow on valve face to "MAN" for manual.
3. Change the ignition cable from the receiver to the valve
(Piezo Ignition tab).
4. Using a small bladed screwdriver, press & hold button
within hole on control. Manually depress piezo igniter button
to light the pilot. If pilot does not light, step 4 can be im-
mediately repeated. If the pilot will not stay lit after several
tries, follow the instructions "To Turn Off Gas to Appliance"
and call your service technician or gas supplier.
5. When the pilot is lit and stable, turn the valve control knob
counterclockwise
height control knob counterclockwise
burner will ignite. Turn flame height control knob to adjust
flame height.
MANUAL MODE - To turn off main burner, turn flame height
control knob fully clockwise
"I/O" button to "O".
Page 14
LIGHTING INSTRUCTIONS
to the "ON" position. Turn flame
and the main
TO TURN OFF GAS TO THE APPLIANCE
. To fully shut down, press
B. Use only your hand to push in or turn the gas control
knob. Never use tools. If the knob will not push in or
turn by hand, don't try to repair it, call a qualified ser-
vice technician. Force or attempted repair may result in
a fire or explosion.
C. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of the
control system and any gas control which has been
under water.
HANDSET MODE - Press "OFF" button on handset. To fully
shut down, press "I/O" button to "O".
"I/O"
(ON/OFF)
SWITCH
28092-8-0614