Installing As A Vented Appliance; Before Fully Installing The Appliance - Empire Comfort Systems VFDR18LBW10N-4 Installation Instructions And Owner's Manual

INSTALLING AS A VENTED APPLIANCE

When installing your log set as a vented installation the damper
clamp must be used.

BEFORE FULLY INSTALLING THE APPLIANCE

cause pilot outage or sooting. Use a heat resistant sealant. Do
Page 12
When installing your log set as a vent-free installation the damper
clamp can be used to eliminate the potential for odors when burning
Installing Damper Clamp
cement or high temperature silicone. Be sure to check the damper
Place the clamp over the lip of the damper and tighten the hold
down bolt until the clamp is securely attached to the damper. This
will prevent the damper from accidentally closing.
Manual and millivolt controlled gas logs may be installed as a vented
decorative log set in compliance with ANSI Z21.60 and National
Fuel Gas Code. When the gas logs are operated with the damper
do not apply.
2. An anchor hole is provided in the two bottom side members of
the grate frame. After centering the grate correctly, mark the hole
holes approximately 1-1/2" deep for masonry screws or 1/8" hole
for sheet metal screws.
provided. Refer to Figure 10.
Figure 10
30726-0-0612
-