Vfdt(18,24,30)Lbw Lighting Instructions - Empire Comfort Systems VFDR18LBW10N-4 Installation Instructions And Owner's Manual

Vented/vent-free burner and logs, unvented gas log heater & vented decorative appliance models
Hide thumbs Also See for VFDR18LBW10N-4:
Table of Contents

Advertisement

FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING:
WHAT TO DO IF YOU SMELL GAS
1.
STOP! Read the safety information above on this page.
2.
Set thermostat (gas control knob) to lowest setting.
3.
Turn off all electric power to the appliance (if applicable).
4.
Push in gas control knob slightly and turn clockwise
to "OFF." Do not force.
5.
Wait ten (10) minutes to clear out any gas. Then smell for
"B" in the safety information above. If you do not smell gas,
go to the next step.
6.
Find pilot - the pilot is located in front of the rear log.
7.
Turn manual gas control knob counter-
clockwise
to "PILOT."
8.
Push in manual gas control knob all the
way and hold in. Repeatedly push the
piezo ignitor button until pilot is lit (or
use a match to light). Continue to hold the control knob in for
about one (1) minute after the pilot is lit. Release knob and it
1.
Set thermostat (gas control knob) to lowest setting.
2.
Turn off all electric power to the appliance if service is to be
performed (if applicable).
30726-0-0612
LIGHTING INSTRUCTIONS
TO TURN OFF GAS TO APPLIANCE
will pop back up. Pilot should remain lit. If it goes out, repeat
steps 4 though 8.
mediately call your service technician or gas supplier
control knob to "OFF" and call your service technician or
gas supplier.
9.
Attention! Gas control has an INTERLOCK latching device.
When the pilot is initially lit and the safety magnet is energized
(pilot stays "ON"), the INTERLOCK latching device becomes
operative. If the gas control is turned to the "OFF" position or
lighted until the safety magnet is de-energized (approximately
60 seconds). There will be an audible "click" when the safety
magnet in the gas control is de-energized. Pilot can now be
relighted. Repeat steps 4 through 8.
10. Turn gas control knob counterclockwise
"HIGH."
11. Turn on all electric power to the appliance (if applicable).
12. Set thermostat (gas control knob) to desired setting from
"HIGH" to "LOW."
3.
Push in gas control knob slightly and turn clockwise
to "OFF." Do not force.
-
-
to
Page 27

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents