Table of Contents
Advertisement
FOR YOUR SAFETY READ BEFORE LIGHTING
WARNING:
WHAT TO DO IF YOU SMELL GAS
1.
STOP! Read the safety information above on this page.
2.
Open bottom louver assembly (if applicable).
3.
Set REMOTE/OFF/ON switch to
"OFF".
4.
Turn off all electric power to the
appliance (if applicable).
5.
Push in gas control knob slightly
and turn clockwise
NOTE: Knob cannot be turned from "PILOT"
to "OFF" unless knob is pushed in slightly.
Do not force.
6.
Wait ten (10) minutes to clear out any gas.
Then smell for gas, including near
Follow "B" in the safety information
above. If you do not smell gas, go
to the next step.
7.
Find pilot - Follow metal tube from
gas control. The pilot is located
next to the burner, near the right
side.
1.
Open bottom louver assembly (if applicable).
2.
Set REMOTE/OFF/ON switch to OFF.
3.
Turn off all electric power to the appliance if service is to be
performed (if applicable).
Page 26
LIGHTING INSTRUCTIONS
to "OFF".
TO TURN OFF GAS TO APPLIANCE
8.
Turn gas control knob counterclockwise
to "PILOT".
9.
Push in control knob all the way and hold in. Repeatedly push
the Piezo Ignitor Button until the pilot is lit. Continue to hold
the control knob in for about one (1) minute after the pilot is
lit. Release knob, and it will pop back up. Pilot should remain
lit. If it goes out, repeat steps 5 through 9.
supplier.
control knob to "OFF" and call your service technician or
gas supplier.
10. Turn gas control knob counterclockwise
11. Set REMOTE/OFF/ON switch to desired setting.
12. Turn on all electric power to the appliance (if applicable).
13. Close bottom louver assembly (if applicable).
4.
Push in gas control knob slightly and turn clockwise
to "OFF". Do not force.
5.
Close bottom louver assembly (if applicable).
-
to "ON".
30726-0-0612
Hide quick links:
Advertisement
Table of Contents
