Table of Contents
Advertisement
Seat Installation (various models)
Attach Seat to Seat Post (fi g 09):
(pre-assembled on some models)
• Loosen nuts on seat clamp (A) and
rotate Seat (8) into riding position.
• Put the seat post (10) fully through the
seat clamp.
• Tighten the Seat Clamp so the seat
stays on the seat post.
• If the Seat Clamp has a nut on each
side, tighten both nuts equally.
CAUTION: If you accidentally drop the seat post into the seat tube, it may be
diffi cult to remove it.
• Point the Seat (8) forward and put the
Seat Post (10) into the Seat Tube (B)
(fi gs 10, 11).
WARNING: To prevent the seat com-
ing loose and possible loss of control, the
"MIN-IN" (minimum insertion) mark (C) on
the seat post must be below the top of the
Seat Tube (B).
Tighten the quick release lever:
• Move the Quick Release Lever (D) to
the "open" position so the word "open"
is pointing away from the Seat Post
Clamp (E).
NOTE: The words "open" and "close" are on
opposite sides of the quick release lever.
12
8
A
B
10
C
fig 10
F
A
10
fig 09
C
B
8
10
B
E
D
fig 11
Advertisement
Table of Contents
