Nexus NX2 Installation And Operation Manual page 52

GPS NAVIGATOR
Navigation tips!
Select WP 001 in the GOTO WP function on the GPS navigator and then select
WP 01 the WAYPOINT mode on the Chart plotter.
Now move the "puck" to the position you want to go to and press the top left button.
That position co-ordinate will then be "transferred" as WP 01. The NEXUS
NAVIGATOR immediately starts navigating towards that WP, whenever a new "WP" to
go to is preferred, move the puck to it and "click". This unique feature makes WP
navigation very easy as there is no need for storing and recalling waypoints.
If you prefer to use the Chart plotter as the tool for fast storing of a great number of
waypoints (over 100), you must first enter the Chart plotters set-up and select WP block
number according to this:
0183 for WP's 00 and up to 099
0183-1 for WP's 00 and up to 099
0183-2 for WP's 00 and up to 099
When this set up is correct, the WP's will be received and stored in the corresponding
NEXUS NAVIGATOR's memory.
9.2 SPECIAL USE TO GET EXTRA WP's.
When two or more navigator instruments are connected to the NEXUS Network and if
more than one "skipper" or family are using the boat, it is sometimes practical to utilise
two completely separate WP bank's.
This can be done by changing the CONFIG in the two instruments, giving two users 399
WP's each. This can also be done with more than two instruments (up to 32 navigator
instruments !!).
Do as follows:
Dedicate the instruments between you "personal" navigators. Enter the CONFIG set up
on "your partners" navigator and set it to NEXUS REPEATER
51