Goto Wp - Nexus NX2 Installation And Operation Manual

GPS NAVIGATOR
6.3.5

GOTO WP

The GOTO WP function is the fastest way of selecting a WP to go
to and it is normally accessed by pressing the SET button once
wherever you are in the NAV page except in DRIFT (where SET
sets the dampening) in the Nav function.
Press PLUS or MINUS to select the waypoint you want to go to.
Press the SET again to select your WP to GOTO, in this example,
"BOUY NE" was the last edited WP.
Last edited WP is displayed
Digits "flashing", ( you may select another WP)
Press the SET to accept this WP and the navigation will start
WP 000 is defined as the "present position" and is used as the
FROM waypoint and WP 134 "BOUY NE" is the TARGET waypoint
4
I
How to use GOTO WP combination with the SAIL PLAN
in
The GOTO WP function is actually a direct jump to the SAIL
PLAN's first LEG (the "active" WP), then replacing that WP with a
new "GOTO WP" waypoint
Example; You have set up a SAIL PLAN with 1 2 WP's and on the
first LEG you are navigating towards is WP134 "BOUY NE", then by
some reason you decide to go to WP1O4 "BOUY NW" instead
To make this easy, start from the Combi Nav display and press
SET to the GOTO WP function, select WP1 04 "BOUY NW", then
press SET again (navigation starts)
Press MINUS to return to the Combi Nav display where you will see
your new Distance and Bearing to "BOUY NW"
Note! The "old" PROM WP will be replaced with "present position"
to begin a new X-N-ack error calculation. When the Arrival alarm
criteria appears, next WP in the SAIL PLAN is activated as normal.
31