Copy Wp - Nexus NX2 Installation And Operation Manual

GPS NAVIGATOR
Press SET and the text FREE is displayed with the WP number
flashing. Accept this free WP by pressing the SET.
Note! When editing an "old" WP you may search for it by scrolling
through the numbers with PLUS or MINUS button. You may also
use the GENERAL WAYPOINT SEARCH, see ch 5.11.
Give your WP a name (optional) and follow the same routine as
described in chapter 6.2.1, then press SET.
Now, the position is shown in latitude and longitude Enter the
correct latitude with PLUS / MINUS and PAGE (cursor) and press
SET Enter correct longitude in the same way and press SET
lat
Note! Make sure you set the correct hemisphere for (N/S) and long
(E/W).
DELETE a WP
You may also delete a WP and make it a FREE position by CLEAR
WARNING!
If you have created a ROUTE and then later change or delete a WP
that is within that ROUTE, the ROUTE will be affected
Our recommendation is to decide early how to organise the
waypoints You may use the first 1 GO WP for "temporary"
waypoints and the rest as more "permanent" WP's for use in
ROUTES Always check that the GPS datum and the chart datum
match
6.2.3

COPY WP

Copy one or a block of WP's to another position without erasing the
original block of waypoints
Press SET
Press SET (first digit flashing)
Select the FIRST WP (12) in the "block" and press SET Select the
LAST WP (200) in the "block" and press SET
27