Table of Contents
Advertisement
2.
Remove the table and wings and set them to
one side.
3.
Loosen the four trunnion mounting bolts as
shown in Figure 30A, and nudge to either
the left or right depending on where the
blade is hitting the saw.
4.
Reattach the table, making sure there is
adequate blade clearance through all blade
adjustments. Recheck guard alignment to
the blade and to the table top. Adjust as nec-
essary and tighten down all the bolts before
use.
5. If the blade is still contacting the insert,
repeat Steps 1-4. Check all other adjust-
ments.
6. Recheck the blade to miter slot adjustments,
and adjust as necessary.
Figure 30B. Adjusting arbor bracket.
-24-
The table and wings rep-
resent a very heavy
load.
DO NOT over-
exert yourself while lift-
ing or moving the table
and wings – get assis-
tance.
Blade Adjustment Cap Screw
Arbor Bracket
To adjust the blade position by moving the arbor
bracket:
1.
Disconnect plug from power source.
2.
Remove the table and wings and set them to
one side.
3.
Loosen the blade adjustment cap screw
shown in Figure 30B.
4. To adjust the arbor bracket, loosen the cap
screw and the setscrew. Slowly slide the
arbor bracket towards the end of the shaft.
5. Moving the arbor bracket moves the V-belts
and pulleys out of alignment, so adjustment
of the motor pulley is required. Simply loosen
the setscrew and slowly slide the pulley
towards the end of the motor shaft. Once the
V-belts are back into alignment, tighten the
setscrew securely.
6. Reattach the table, making sure there is ade-
quate blade clearance through all blade
adjustments. Recheck guard alignment to
the blade and to the table top. Adjust as nec-
essary and tighten down all the bolts before
use.
7. If the blade is still contacting the insert,
repeat Steps 1-6. Check all other adjust-
ments.
8. Recheck the blade to miter slot adjustments,
and adjust as necessary.
G7209/10 14'' Table Saw
Advertisement
Table of Contents
