Workstop; Vise - Grizzly G0613/G0614 Owner's Manual

Swivel mast metal cutting bandsaw
Table of Contents

Advertisement

Workstop

Your bandsaw has an adjustable workstop (Figure
14) that is easy to install and to use.
To install the workstop:
1.
Thread the workstop rod in the base and
tighten the jam nut.
2.
Slide the workstop onto the rod.
Jam Nut
Workstop Rod
Figure 14. Workstop assembly.
3.
Measure the distance from the blade to the
workstop, slide workstop to the needed posi-
tion and tighten the lock lever.
G0613/14 Swivel Mast Metal Cutting Bandsaw
The vise has a quick tighten/release lever and,
depending on the cut angle or workpiece shape,
you can remove or install the aluminium vise
clamp plate (Figure 16) for additional holding
force.
To use the vise:
1.
Workstop
Lock
Lever
2.
3.
Handwheel
4.

Vise

Raise the bow and lock it in place by closing
the feed ON/OFF valve (Figure 15).
Feed ON/OFF
Figure 15. Feed ON/OFF Valve.
Insert the workpiece between the jaws.
Use the handwheel (Figure 16) to move the
jaws so they are within 1/8" from clamping
the workpiece.
Figure 16. Vise options and controls.
Use the vise lock lever to hold the workpiece
and quickly release the jaws to move the
workpiece after a cut.
Aluminum Plate
Vise Lock Lever
-21-

Advertisement

Table of Contents
loading

This manual is also suitable for:

G0613G0614

Table of Contents