8.
Double check bearing adjustments.
9.
Adjust the other blade guide, and reinstall the
blade guide guards and the limit switch.
10. Adjust the auto stop bolt and the bow stop
bolt (Figure 42), so the bandsaw motor will
stop when the blade teeth are just below the
vise table surface.
11. Go to Setting Stops on Page 38 and com-
plete the steps to make sure the cuts will be
perpendicular to the table.
G0613/14 Swivel Mast Metal Cutting Bandsaw
Bow
Stop
Bolt
Figure 42. Auto stop and bow stop bolts.
Limit Switch and
Auto Stop Bolt
-35-