Table of Contents
Advertisement
Fence
To install the fence:
1
1.
Use the
⁄
"-20 x 1" hex bolts, nuts and wash-
4
ers to attach the fence brackets to the table
as shown in Figure 21.
Figure 21. Fence supports to table.
2.
Slide the fence rails into the brackets and
mount the fences on the ends with the
3
x
⁄
" hex bolts. The smaller rail is meant for
4
the side fence and the larger rail for the front
fence. The adjustment knobs fit on top of the
brackets. The finished assembly should look
like Figure 22.
Figure 22. Fences installed on supports.
-16-
The stand covers come with attached catch tabs.
Cut the catch tabs off as shown in Figure 23.
Figure 23. Remove tabs from stand covers.
Locate the (12) small Phillips
the tabs (raised side down) to the stand covers
as shown in Figure 24. Tighten the catch tabs
enough to give resistance so they will stay in
1
⁄
"-20
place, but not tight enough that you will not be
4
able to turn them.
Figure 24. Catch tabs in place on stand cover.
The stand covers fit inside the stand openings
and attach by turning the catch tabs over the
edges of the stand.
Stand Cover
®
screws and attach
G5787 Meatcutting Bandsaw
Advertisement
Table of Contents
