V-Belt; Pulley Cover - Grizzly G0561 Owner's Manual

V-Belt

The V-belt needs to be tensioned or repositioned
for your desired RPM.
To tension or reposition V-belt:
1.
DISCONNECT MACHINE FROM POWER!
2.
Loosen the two hex bolts on motor mount
bracket (see Figure 17).
Figure 17. Location of V-belt tension hex bolts.
3.
Adjust the two hex bolts on motor mount
plate to loosen belt (see Figure 17).
4. Slip V-belt over combination of pulleys to get
desired RPM. Make sure belt is on parallel
sheaves. See chart on inside of pulley cover
for RPM choices.
5.
Retension belt. Apply enough tension so belt
deflects about ⁄ " with moderate pressure
1
4
when pinched together between center of
pulleys.
Model G0561 (Mfd. Since 01/08)
Step 3
Step 2

Pulley Cover

Components and Hardware Needed:
Pulley Cover ......................................................1
Collar ..................................................................1
Hex Bolts ⁄ "-20 x ⁄ " .........................................2
1 1
4 2
Flat Washers ⁄ " .................................................2
1
4
Knob ⁄ "-20 x ⁄ " ................................................1
1 5
4 8
To install the pulley cover:
1.
Slide the collar onto the bottom side of the
pulley cover and snap in place, as shown in
Figure 18.
Figure 18. Collar installed.
Entanglement
You MUST install the pul-
ley cover before operat-
ing or severe injury may
occur.
Qty
Collar
Hazard!
-19-