Longhand Programming - Avaya IP Office 2420 User Manual

7.5 Longhand Programming

1. Press Admin. See
2. To switch to longhand programming mode, press Expl?
3. Press Next until the required function required is shown, then press Selct
4. If the function requires some data to be entered, [ ] is shown at the bottom of the display. Enter the data using the
normal phone keypad. The upper part of the display reverts to showing the functions currently assigned to
.
5. To move between the pages of display keys, press
6. To select the display key against which to program the new function, press
Caution
· Do not select the slot used for the Admin function. Replacing this function will lock the phone for further
programming until reset through the phone system.
7. If the display slot is not already used, the display shows BUTTON PROGRAMMED!.
To end programming, press
·
To continue programming other functions, press
·
9. If the display slot already has a programmed function, the display shows FEATURE ON BUTTON. Repla, Keep and
Delet are shown along the right-hand edge of the display.
To replace that existing function with the one just programmed, press Repla
·
BUTTON PROGRAMMED! as above.
To keep the existing function and forget the function just programmed, press Keep
·
To delete the existing function and forget the function just programmed, press Delet
·
2420/5420 Phone
IP Office
Display Key Programming
EXIT.
Function Keys: Shorthand Programming Mode
.
50
.
and .
Cont.
.
or .
. The display then shows
.
.
15-601127 Issue 09a (16 July 2009)
and
Page 53