1.3 Mini Intelli-Jet Cleaning Procedure - Sundance Spas CAMEO Installation & Owner's Manual

1 1.3 Mini Intelli-Jet Cleaning Procedure

If you experience a sticky rotational Mini Intelli-Jet, perform the following
cleaning procedure. In most of these cases debris is present in the jet bear-
ings and must be cleared to achieve proper operation. Note: This procedure
is considered normal maintenance for this type of jet.
Procedure
1. Remove jet internal from hot
tub wall fitting by placing
your hand around the outer
jet adjustment ring and
rotating it counterclockwise.
Rotate jet adjustment ring
until it stops at position (A).
Use additional force at posi-
tion (A) to continue rotation
until you feel a "click" at
position (B); then feel the
internal release at position
(C). It may seem like your
are overtorquing the jet
internal between positions (A-B), however, additional force is necessary at
position (A) to unlatch its retaining mechanism from the wall fitting.
2. Fill a clean bucket with tap water and immerse the jet internal. Rotate
the submersed jet internal's nozzle in a circular motion while moving it
back and forth allowing water to flow through both ends of the jet. This
motion allows slow moving water to wash back through the jet bearing
and dislodge any debris that might be lodged in the bearing. Clean each
jet internal for approximately 1 to 2 minutes twice a year, or when a
particular jets rotation appears sluggish, jerky, or obstructed.
3. Reinstall the jet internal by inserting it in any jet opening of the same jet
type. Rotate the jet internal clockwise with light pressure until your feel
the retaining mechanism "snap" in place. The jet's nozzle should rotate
freely to the left or right using only fingertip pressure. If jet rotation
appears sluggish or obstructed at this time, repeat steps 2-3 until condi-
tion clears. If condition persists, contact dealer for technical support.
Page 38
C
Release Position
B
"Click" Position
A
Stop Position
Outer Jet
Adjustment
Ring (X)