Sundance Spas CAMEO Installation & Owner's Manual page 34

will animate a 3-D rotating disc while the CD is playing. Note: if CD
play time is not shown, press clock set button (9) once.
• To remove CD: open the front panel and press the CD eject button
located under the front panel. Remove CD from drive and close front
panel. CAUTION: listen for an audible click to ensure the front
panel is closed to prevent water intrusion that could damage
your unit.
B. Changing CD Tracks and Music Seek
To advance to the next track, press the tune/seek-up button (13) once and
the track counter will increase one track. When the final track is reached
on the CD, play will resume on track #1.
• To fast forward through tracks: press and hold the tune/seek-up
button (13) until the track counter displays the desired track, then
release the button.
• To return to the beginning of the current track: press the tune/seek-
down button (14). Pressing it a second time within 1 second will skip
back to the previous track.
• To rewind the current track: press and hold the tune/seek-down button
(14). The track will quickly rewind until you release the button.
C. Intro Scan, Random, Repeat
• Intro Scan Mode: press intro button (21) to enter intro scan mode.
The left side of the display reads "SCN" and the first 10 seconds of
each CD track will play continuously until you press the intro button a
second time, or press either tune/seek-up button (13) or tune/seek-
down button (14).
• Random Mode: press the random button (19) to play the CD tracks in
random order. The left side of the display reads "RDM" when random
mode is enabled.
• Repeat Mode: press the repeat button (18) to repeat the current CD
track continuously. The left side of the display reads "RPT" when
repeat mode is enabled.
Optional SunSound
A. Unit will not turn-on
Make sure spa power is turned on, then check both harness fuses on back
of unit making sure they are the proper ratings:
• Yellow memory B+ line (1A fuse); Red ACC line (10A fuse).
• With spa power off, use a thin rod to press the reset button located
Page 28
TM Stereo Receiver Troubleshooting