Sundance Spas CAMEO Installation & Owner's Manual page 52

PUMP DOES
NOT OPERATE
BUT BLOWER
AND LIGHT DO
OPERATE
Pump Priming Instructions: Turn Hot Tub Off!
Remove filter and insert end of garden hose into left-side filter fitting. Seal-
off fitting opening around hose using a large, clean rag and hold in place.
Ask a helper to turn on maximum water flow through the garden hose. After
about 30 seconds, turn off water. Repeat process for right-side filter
fitting, then remove hose and rag. Reinstall filter as illustrated in section
1 1.1 (page 35-36) and activate pump 1 in high speed. Another method of
priming the hot tub's pump(s) is as follows:
1. Turn off the power to the hot tub.
2. Remove the handle from the massage selector supplied by the pump
you are priming.
3. Loosen the massage selector's cap slightly (counterclockwise),
listening for the air to seep out.
4. Tighten the cap finger-tight, replace the handle and turn the hot tub's
power back on (continued on next page).
(Note: This method must be used for the single speed pump (pump #2)
of all Altamar, Cameo, Marin, and Optima models because pump #2 is
not connected to the filter.)
IMPORTANT: If freezing conditions exist and pump is not operational,
take measures to protect the system from freeze damage. See
"Winterizing" (page 40).
POOR JET ACTION
(Figure-F, Page 17)
Page 46
Depress "JETS" sensor.
1. If no sound is detected or if a "buzzing" sound is
detected, turn off power to the hot tub and
contact your dealer or service center.
2. If motor operates but no water flows to jets:
a. Pump may not be properly primed. See
instructions below.
b. Contact dealer or authorized service center.
1. Make certain the pump is on high speed.
2. Check position of massage selectors
3. Open air control for selected jet system.
4. Check for adequate water level.
5. Check for dirty filter (page 35-36).