Adjusting Fluidix Reflex, Nex, St, Intelli-Jets And Focus-Relief; Air Controls; Waterfall Control - Sundance Spas 880 Series Owner's Manual

11.8 Adjusting Fluidix Reflex, Nex, ST, Intelli-Jets And Focus-
Relief
These jets in your new hot tub offer the advantage of no
moving parts and zero maintenance. They can also be adjust-
ed for a high and low impact massage, providing the ultimate
massage! To adjust jets:
1. Fluidix Nex/Intelli-Jets and Reflex Jets only: Turn outer
dial (A) clockwise to increase water volume. Turn outer
dial counterclockwise to decrease water volume or to shut
jet off.
2. Fluidix Intelli-Jet only: Rotate center "mode disk" (B)
clockwise to select a non-oscillating water stream or turn
counterclockwise to select an oscillating stream at any
angle.
3. For a high impact massage, turn corresponding air control
knob clockwise. For the Fluidix ST jet, this will create
a straight water flow. For low impact massage, turn
corresponding air control knob counterclockwise. For the
Fluidix ST jet, this will create an oscillating flow. Refer to
Section 9.0 (page 24) for specific operation details. The
included tool (shown) allows you to position the jet nozzle
angle to your liking. This tool can also be used to aid in the
opening or closing of the nozzle on Fluidix Reflex jets.
4. Focus-Relief Jets: Work with both the blower and jets
pump. The blower introduces air to the jet and the jets pump forces
water through.
Note: Always keep at least 6 adjustable jets open at all times on each jet
system.
11.9

Air Controls

Each jet system has its own air control. These controls allow
you to regulate the amount of air which is mixed with the water
entering through the jets. Clockwise rotation adds more air and
counterclockwise rotation reduces air flow.
Note: To minimize heat loss, close all air controls when spa is not in
use. Certain jets may draw air even though they are closed. This is
considered normal.

11.10 Waterfall Control

Turn waterfall control valve counterclockwise to increase
waterfall(s) output. Turn control valve clockwise to decrease or
turn off waterfall(s) output.
Note: It takes 2 full revolutions to change the waterfall from a full off to
a full on flow rate. When the waterfall is in the OFF position some water
may still flow through. This is considered normal.
880 Export Series
A B
Fluidix Intelli-Jet
A
Fluidix Reflex Jet
Fluidix ST Jet
Focus-Relief Jet
33