Temperature Setting Lock; 1.0 Hot Tub Maintenance; 1.1 Cleaning The Filter - Sundance Spas CAMEO Installation & Owner's Manual

To Unlock The Panel: Press DISPLAY, MODE, and DOWN, in order,
within five seconds. The "lock" symbol will disappear. All sensor pads
LOCKED
are now active.

10.7 Temperature Setting Lock

To electronically lock the temperature setting, first enter the "temperature
setting" mode by pressing UP or DOWN. Then, within five seconds, press the
three sensors described under "Panel Lock" above. This will prevent the tem-
perature setting from being changed by unauthorized persons but all other
sensors will remain active. To unlock the temperature setting so that it can
be adjusted, simply follow the instructions above under "To Unlock The
Panel."

11.0 Hot Tub Maintenance

Proper and regular maintenance of your hot tub will help it retain its beauty
and performance. Your authorized Sundance Dealer can supply you with all
the information, supplies, and accessory products you will need to accom-
plish this.

1 1.1 Cleaning The Filter

A programmable "Change Filter" reminder flashes on the
CHANGE
control panel display after a specified number days to remind
FILTER
you to clean (or replace) your filter cartridge(s). This reminder
must be reset at each cleaning interval. Refer to section 10.3 (page 33) for
additional information and programming details.
Your Sundance hot tub is equipped with an exclusive MicroClean TM 2-stage
filter located under the filter lid (Figure-F, Page 17). Fine debris is filtered by
the circulation pump drawing water through the smaller (stage 2) cartridge.
Larger debris is filtered by the main 2-speed pump drawing water through
the larger (stage 1) cartridge during normal operation and at each skim-
ming/heating cycle. Both halves work together to give you unsurpassed
water quality! To ensure optimum performance, clean and reuse the stage
1 cartridge once a month and throw-out (replace) the stage 2 cartridge
every 3 months, or as needed.
All models include filters on their footwell suction covers (Page 1 7)
that prevent debris from entering pump 2 and the diverter valve(s),
when operating. These filters must remain in place to protect these
components from debris entrapment/damage. They should be
cleaned every 2 months, or when weak pump 2 performance is observed.
Page 35