Naming Your Extension; Adjusting The Telephone Display; Configuring Ssl Vpn Service - Avaya ETR 6 User Manual

5. Phone Settings

5.1 Naming Your Extension

You can assign a name to your extension, up to 15 characters long. The name is then displayed on the phone and also on
other extensions when you make or receive calls.
To Change Your Extension Name (ETR 18D/34D)
1. At the phone press Feature 00.
2. Program Extension: is shown on the display.
3. Press Intercom 1.
4. Enter the extension name.
· Enter a character by pressing the indicated button until that character is displayed. If you pause more than 1
second after press a button, the cursor will move onto the next space.
1 1!"$%&'()+,-./
4
7
* *:;<=>?@[\]^_`
· Do not use punctuation characters such as #, ?, /, -, _ and , in the name. Start the name with an alphabetic
character. Note that the name is case sensitive and must be unique.
· To remove the current name, press the MIC/HFAI key.
· Exit programming by pressing Feature 00. You can also exit programming mode by lifting the handset, then
placing it back in the cradle.

5.2 Adjusting the Telephone Display

The phone must be idle and the handset must be in its cradle when you adjust the display contrast.
To adjust the display brightness
1. With the extension idle, press *.
2. Use the up arrow and

5.3 Configuring SSL VPN Service

Using the system administration option, it is possible to put the SSL VPN Service, which exists on <%IPOFFICE%> Basic
Edition, in and out of service. This feature is not available on ETR 6/ETR 6D phones.
Note: The phones must be plugged into the first two ports of the first card on the IP500 V2.
1. At the phone, press FEATURE 0 0, and then press the Intercom 1 button twice.
The System Administration menu appears.
2. Select SSL VPN Service using the NxPrc/PrPrc keys. Alternatively, from the System Admin menu, you can
dial # 7 7 5 (#SSL) to access the SSL VPN Service sub-menu.
3. Use the Next Item and Previous Item buttons to select the appropriate tunnel and press Enter.
The name and status of the selected tunnel is shown (1=Active, 2= Not Active).
4. Dial 1 or 2 to activate/deactivate the selected tunnel. You can also use the Next Data and Previous Data
buttons to change the setting. You can still use the Next Item and Previous Item buttons to scroll through the
list of remaining tunnels.
· If you press Remove, the selected tunnel is set to 'Not Active.'
· Exit programming by pressing Feature 00. You can also exit programming mode by lifting the handset, then
placing it back in the cradle.
PARTNER® Mode ETR Phone User Guide
IP Office Basic Edition
4ghiGHI
7pqrsPQRS
down arrow keys to change the display brightness.
2 2abcABC
5 5jklJKL
8 8tuvTUV
0 0 Space
3 3defDEF
6 6mnoMNO
9 9wxyzWXYZ
# #
- Issue 4e (Friday, May 04, 2012)
Page 42