Advertisement
Models
2607A
2608A
2610A
2611A
See Connection diagrams for warnings.
IMPORTANT NOTICE
This manual contains important safety and operating instructions for the charger. Read
the entire manual before using. Also read all instructions and cautions for and on the
charger, batteries and equipment in the vicinity of the batteries.
1. INTRODUCING THE CHARGER
The Guest model 2607A, 2608A, 2610A and 2611A are designed to both recharge
your batteries, and extend your battery's life in applications where it is stored for long
periods of time. They are "3-stage" electronic, completely automatic, lightweight, silent,
battery chargers and each output produces 12 Volts DC at either a full 3, 6 or 5 Amps
(model specific), while using much less AC current than other charger types. Unlike
automotive "trickle" chargers, the 2607A, 2608A, 2610A and 2611A will not boil off the
electrolytes in properly installed and maintained batteries. The red and green LED's,
mounted on the charger face, let you know the unit is recharging and maintaining your
batteries. This sophisticated device is ideal for recharging and maintaining the 12VDC
batteries in your boat, electric vehicle or cart, ATV, snowmobile or motorcycle.
Trolling Charger Series
OWNER'S MANUAL
ON BOARD BATTERY CHARGERS
Amperage
3, 3 Amps
6 Amps
5, 5 Amps
5, 5 Amps
SAVE THESE INSTRUCTIONS
No. Of Banks
2 Bank
1 Banks
2 Banks
2 Banks
R
Volts
12/24
12
12
12/24
Advertisement
Table of Contents
Related Manuals for Guest Trolling Charger 2607A
Summary of Contents for Guest Trolling Charger 2607A
-
Page 1: Introducing The Charger
12 Volts DC at either a full 3, 6 or 5 Amps (model specific), while using much less AC current than other charger types. Unlike automotive “trickle” chargers, the 2607A, 2608A, 2610A and 2611A will not boil off the electrolytes in properly installed and maintained batteries. The red and green LED’s, mounted on the charger face, let you know the unit is recharging and maintaining your batteries. - Page 2 WARNINGS THIS CHARGER SHOULD BE USED TO CHARGE ONLY LEAD ACID, GEL CELL, OR AGM BATTERIES. USE ON OTHER BATTERY TYPES MAY EXPLODE AND CAUSE PERSONAL INJURY. RISK OF EXPLOSIVE GASES! WORKING IN THE VICINITY OF LEAD ACID BATTERIES IS DANGEROUS. BATTERIES GENERATE EXPLOSIVE GASES DURING NORMAL OPERATION.
-
Page 3: Installing The Charger
Add distilled water in each cell until battery acid reaches levels specified by the battery manufacturer, if applicable. Do not overfill. For all batteries, carefully follow the manufacturer’s recharging instructions. Never allow the ring terminals to touch each other. NEVER charge a frozen battery. Please be sure the DC system to which the charger is connected is not drawing excessive current from the battery for extended periods of time while the charger is operating. - Page 4 Size (inches) Input Model Banks Input Volts Volts Amps Size L x W x H Amps Max 115VAC 2607A 12/24 4’/4’ 3.5 x 6.4 x 2.25 2 Amp 50/60Hz Diagram 1. 2607A (3/3 Amps) used with 2 independent 12V Batteries...
-
Page 5: 2607A Connections
2607A Connection Warnings: For the 2607A, output 1 and output 2 may be connected in parallel for a 12 V 6 amp output. Both outputs may also be connected in series for a 24 V output, see below. 2607A Connections... - Page 6 2608A Connections Output Output DC Cable Size (inches) Input Model Banks Input Volts Volts Amps Size L x W x H Amps Max 115VAC 2608A 4’ 3.5 x 6.4 x 2.25 2 Amps 50/60Hz Diagram 3. 2608A (6 Amps) used with 1 12V Battery...
- Page 7 2611A Connections Output Output DC Cable Size (inches) Input Model Banks Input Volts Volts Amps Size L x W x H Amps Max 115VAC 2611A 12/24 4’/4’ 4.25 x 7 x 2.42 2.5 Amps 50/60Hz Diagram 4. 2611A (5/5 Amps) used with 2 independent 12V Batteries 2611A Connections: For the 2611A, Output 1 and output 2 may be connected in parallel for a 12 V 10 amp output.
- Page 8 2611A Connections Diagram 5: 2611A used in a 24 V system...
- Page 9 2610A Connections Output Output DC Cable Size (inches) Input Model Banks Input Volts Volts Amps Size L x W x H Amps Max 2610A 115VAC 4.25 x 7 x 2.42 2.5 Amps 50/60Hz Diagram 6: 2610A (5/5 Amps) used with 2 12V Batteries 14 or 15 AMP FUSE FOR EACH CUTPUT.
- Page 10 2610A Connections Diagram 7: 2610A used in a single battery system LISTED 14 OR 15 AMP FUSE.
- Page 11 3. OPERATING THE CHARGER – 6 amp output The LED Function Chart describes the charging process for any individual 6 Amp output. Display Operating condition When the red LED is on, it indicates that your batteries are discharged and is recharging them at the "Charging"...
- Page 12 OPERATING THE CHARGER – 5 amp output The LED Function Chart describes the charging process for any individual 5 Amp output. Display Operating condition When the red LED is on, it indicates that your batteries are discharged and is recharging them at the "Charging" rate (stage 1). This charging rate is 5 Amps.
- Page 13 OPERATING THE CHARGER – 3 amp output The LED Function Chart describes the charging process for any individual 3 Amp output. Display Operating condition When the red LED is on, it indicates that your batteries are discharged and is recharging them at the "Charging" rate (stage 1). This charging rate is 3 Amps.
-
Page 14: Troubleshooting
1. No AC power available at the 1. Connect AC power or reset the LED’s turn on charger AC breaker on the main panel when the AC 2. Charger failure 2. Return charger to the Guest power is applied. Service Dept. -
Page 15: Maintaining The Charger
Size (inches) Input Model Banks Input Volts Volts Amps Size L x W x H Amps Max 115VAC 2607A 12/24 4’/4’ 3.5 x 6.4 x 2.25 2 Amps 50/60Hz 115VAC 2608A 4’ 3.5 x 6.4 x 2.25 2 Amps 50/60Hz... - Page 16 LIMITED WARRANTY For two (2) years from the date of original purchase, The Guest Co. will, at its discretion, repair or replace for the original consumer, free of charge, any parts found defective in material or workmanship. All transportation charges under this warranty must be borne by the customer.