Related Manuals for Guest 2602A-12
Summary of Contents for Guest 2602A-12
- Page 1 A Valley Forge Company MODEL 2602A-12 3 STAGE AUTOMATIC BATTERY CHARGER OWNER’S MANUAL SAVE THESE INSTRUCTIONS...
-
Page 2: Introducing The Charger
2602A-12 will not boil off the electrolytes in properly installed and maintained batteries. When the 2602A-12 is attached to your batteries and plugged into a standard 115 volt / 60 Hz AC outlet, the green LED lets you know the unit is maintaining your batteries. -
Page 3: Installing The Charger
Preparing to Charge Precautions Before charging a battery with the charger, read the following precautions: 1. Do NOT operate the charger if the cables or LED are damaged. 2. Make sure all external electrical loads are OFF. 3. If the battery or batteries must be removed from the equipment in which the charger is mounted, always remove the grounded terminal from the battery first. -
Page 4: Operating The Charger
4. OPERATING THE CHARGER Proper Operation When the 2602A-12 charger senses a drop in battery voltage, it automatically increases its output to re-charge the battery. By using a sophisticated three-stage charging method, it can fully recharge your batteries in the fastest, healthiest way. -
Page 5: Troubleshooting
OK and proceed to are drawing more troubleshoot. If it does not current than the light, contact the Guest Co. charger can replace. 4. No AC power available 4. Connect AC power or reset the at the charger. -
Page 6: Specifications
7. SPECIFICATIONS Output: Charging: 12 Volts DC(min.) at 2 Amps Maintaining: 13.3 Volts DC at 0.1 Amps Input: Rated AC Voltage 115 VAC, 60 Hz Current Draw 1.0 Amps at full output Maximum recommended battery size: For recharging: Up to 30 Amp-Hours Maintenance only: Up to 100 Amp-Hours Physical Dimensions:... - Page 7 LIMITED WARRANTY For two (2) years from the date of original purchase, The Guest Co. will, at its discretion, repair or replace for the original consumer, free of charge, any parts found defective in material or workmanship.