Guest 2606A Operation Manual
  1. Manuals
  2. Brands
  3. Guest Manuals
  4. Battery Charger
  5. 2606A
  6. Operation manual

Guest 2606A Operation Manual

Hide thumbs Also See for 2606A:
Table of Contents

Advertisement

Available languages

Available languages

Quick Links

See also: Owner's Manual
operations manual
marinco.com
Model 2606A/2606A-B
ConneCtions At A glAnCe
The Guest MTC Model 2606A is designed to be used as a general purpose charger for
lead acid batteries (flooded cell or AGM types) and gel cell batteries. We recommend that
you set up the charger near the battery you wish to charge, and make connections in the
following order:
• Charger POS (red wire with fuse) to battery " + ".
• Charger NEG (black wire) to battery " – ".
• Plug AC line cord into a GFCI protected wall socket.
• Remove connections in the reverse order.

1. intRoDUCing tHe CHARgeR

The GUEST MTC 2606A is designed to both recharge your battery, and extend your
battery's life in applications where it is stored for long periods of time. The 2606A is a
"3-stage" electronic battery charger. Lightweight, silent, completely automatic, and reverse
polarity protected, it produces 12 Volts DC at a full 6 Amps, while using much less AC
current than older chargers. Unlike automotive "trickle" chargers, the 2606A will not boil off
the electrolyte in properly installed and maintained batteries. When the 2606A is attached
to your battery and plugged into a standard 115 Volt / 60 Hz AC outlet, the red and green
LED's let you know the unit is recharging and maintaining your battery.

2. iMPoRtAnt sAFetY instRUCtions

This manual contains important safety and operating instructions for the charger. Read the
entire manual before using. Also read all instructions and cautions for and on the charger,
batteries and equipment in the vicinity of the batteries.
tHis CHARgeR sHoUlD Be UseD to CHARge onlY 12Volt DC leAD
WARning
!
ACiD, AgM oR gel Cell tYPe BAtteRY sYsteMs. Use on otHeR tHAn A 12
VDC sYsteM CAn CAUse tHe BAtteRY to eXPloDe AnD CAUse PeRsonAl
inJURY.
RisK oF eXPlosiVe gAses! WoRKing in tHe ViCinitY oF A leAD ACiD

Advertisement

Table of Contents
loading

Related Manuals for Guest 2606A

Summary of Contents for Guest 2606A

  • Page 1: Introducing The Charger

    The GUEST MTC 2606A is designed to both recharge your battery, and extend your battery’s life in applications where it is stored for long periods of time. The 2606A is a “3-stage” electronic battery charger. Lightweight, silent, completely automatic, and reverse polarity protected, it produces 12 Volts DC at a full 6 Amps, while using much less AC current than older chargers.

  • Page 2: Personal Safety Precautions

    Model 2606A/2606A-B operations manual BAtteRY is DAngeRoUs. A BAtteRY geneRAtes eXPlosiVe gAses DURing noRMAl oPeRAtion. tHeReFoRe it is oF UtMost iMPoRtAnCe tHAt eACH tiMe BeFoRe Using YoUR CHARgeR YoU FolloW tHe instRUCtions eXACtlY. To reduce risk of battery explosion, follow these instructions and those published by battery manufacturer and manufacturer of any equipment you intend to use in vicinity of battery.

  • Page 3: Installing The Charger

    Model 2606A/2606A-B 8.Use charger for charging a lead acid, AGM or gel battery only. It is not intended to supply power to a low voltage electrical system other than in a starter motor application. Do not use charger for charging dry cell batteries that are commonly used with home appliances.These batteries will burst and cause injury to persons and damage...

  • Page 4: Dc Connection Precautions

    Model 2606A/2606A-B operations manual horizontal surface may cause the charger to slightly reduce amperage output due to the thermal protection built in. Do not install the charger on carpeted, upholstered, or varnished surfaces. 2. Locate charger as far away from battery as dc cables permit.

  • Page 5: Operating The Charger

    If the green LED stays on when your battery is known to be low, refer to Problem 3 in the troubleshooting section in this manual. When the red LED is flashing on and off, the 2606A is connected in reverse polarity (positive charger output terminal to negative battery post and negative charger output terminal to positive battery post).

  • Page 6: Troubleshooting

    1. No AC power available at the 1. Connect AC power or reset the LED’s charger the AC breaker on the main turn on 2. Component failure panel when the 2. Return charger to the Guest AC power is Service Dept. applied.

  • Page 7: Maintaining The Charger

    Model 2606A/2606A-B 6. MAintAining tHe CHARgeR Periodically clean both battery terminals with baking soda and tighten all connections. No other maintenance on the charger is required. 7. sPeCiFiCAtions output: Charging: 12 Volts DC(min.) at 6 Amps Maintaining: 13.30 Volts DC at 0.1 Amps...

  • Page 8: Limited Warranty

    Model 2606A/2606A-B operations manual liMiteD WARRAntY For two (2) year from the date of purchase, The Guest Co. will, at its discretion, repair or replace for the original consumer, free of charge, any parts found defective in material or workmanship.

  • Page 9: Consignes De Sécurité Importantes

    Le 2606A est un chargeur de batterie électronique à « 3 étapes ». Léger, silencieux, complètement automatique, et protégé contre la polarité inversée, il produit 12 Volts CC à...
  • Page 10 Modèle 2606A/2606A-B manuel d’opération D’ACCUMUlAteURs AU PloMB est DAngeReUX. les BAtteRies gÉnÈRent Des gAZ eXPlosiFs DURAnt Un FonCtionneMent noRMAl. il est DonC eXtRÊMeMent iMPoRtAnt De sUiVRe CHAQUe Fois et eXACteMent les instRUCtions AVAnt D’UtiliseR VotRe CHARgeUR. Afin de réduire le risque d’explosion de la batterie, suivre ces instructions et celles publiées par le fabricant de la batterie et le fabricant de tout équipement que vous...
  • Page 11 Modèle 2606A/2606A-B 7.Enlever tous les objets personnels en métal tels bagues, bracelets, colliers et montres lorsque vous travaillez près des batteries d’accumulateurs au plomb. Une batterie peut produire des courants de court-circuit assez élevés pour souder une bague ou autre au métal, causant des brûlures sévères.
  • Page 12 Modèle 2606A/2606A-B manuel d’opération Ne jamais altérer le cordon CA ou la fiche fournie – s’ils ne s’adaptent pas DAngeR à la prise, faire installer une prise appropriée par un électricien qualifié. Une mauvaise connexion peut causer un risque de choc électrique.

  • Page 13: Fonctionnement Du Chargeur

    Problème 2 dans la section dépannage du présent manuel. Lorsque le DEL vert est allumé, le 2606A charge à un niveau « FLOAT » ou « MAINTENANCE » de moins de 1,5 Amp (étape 3). Votre batterie est maintenant chargée à 90% et prête à utiliser. Ce courant de charge «...

  • Page 14: Dépannage

    Modèle 2606A/2606A-B manuel d’opération Model 2607 A-B operations manual 5. DÉPAnnAge Problème Cause solution 1. Le DEL 1. Un ou plusieurs éléments dé 1. Faire un test de charge rouge reste fectueux ou endommagés. de la batterie et remplacer 2. Le chargeur a réduit sa tension de si nécessaire.

  • Page 15: Entretien Du Chargeur

    Modèle 2606A/2606A-B 6. entRetien DU CHARgeUR Nettoyer périodiquement les deux bornes de batterie avec du bicarbonate de soude et serrer les connexions. Aucun autre entretien requis sur le chargeur. 7. sPÉCiFiCAtions sortie : Chargement : 12 Volts CC (min) à 6 Amp Entretien : 13,30 Volt CC à...

  • Page 16: Garantie Limitée

    Modèle 2606A/2606A-B manuel d’opération gARAntie liMitÉe Deux (2) ans à partir de la date d’achat. The Guest Co. réparera ou remplacera, à sa discrétion, pour l’acheteur original, sans frais, toutes pièces défectueuses au niveau du matériel ou de la main d’œuvre.

This manual is also suitable for:

2606a-b

Table of Contents