Warming Shelves Installation - Heat & Glo TIARAII-BK-B Owner's Manual

L. Warming Shelves Installation
Kit Contents: (2) Warming shelves, (2) brackets, and (4)
1/4 in. Phillips head screws.
Tools Required: Phillips head screwdriver.
Figure 8.29 Remove warming shelves and hardware from
packaging. Install leveling screw to each warming shelf.
Figure 8.30 Install warming shelf bracket loosely to each
warming shelf using the screw provided.
Figure 8.31
Gently lift cast top off of appliance and set
aside. Install warming shelf to appliance gently aligning
the shelf with the tabs that are in place on the side of the
appliance. Use the leveling screw located in the center of
the warming shelf to adjust the shelf to its desired position.
34
Figure 8.32
screw to hold it in place. Reassemble the appliance.
Heat & Glo • TIARA II-B • 7011-148 Rev. D • 12/11
Align bracket to fi rebox and gently tighten the