Heat & Glo TIARAII-BK-B Owner's Manual page 32

J. Optional Blower (Cont'd)
BLOWER
CONTROL
KNOB
GROUND
CLIP
CONTROL
NUT
SPEED
CONTROL
Figure 8.22 Compare CONTENTS OF CARTON with the
actual parts received. If any parts are missing or damaged,
contact your dealer before starting installation. Do not
install a damaged blower kit.
Figure 8.23 From the rear of the appliance, slide the blower
into the blower housing with the magnetic strips down. The
blower openings should be at the front.
Plug blower power cord into fan outlet on junction box.
Figure 8.24 Attach grounding clip supplied with the kit to the
blower housing. Attach ground wire to grounding clip.
32
WING
NUT
TEMP.
SENSOR
SWITCH
Heat & Glo • TIARA II-B • 7011-148 Rev. D • 12/11
WING NUT
Figure 8.25
Slide temperature sensor switch/bracket
assembly onto the 10-32 screw located on the left
underside of the appliance. Secure the bracket assembly
with the wing nut provided.
Disconnect the two wire ends connected together on
the junction box. Connect female end to one side of
temperature sensor switch.
Connect one end of the black wire provided with the kit to
the remaining wire end on junction box.
Feed loose ends of the black and blue wires through the
orange grommet in fan housing.
SCREWS
Figure 8.26
Remove valve access cover from back of
appliance by removing the three screws indicated.
SPEED CONTROL
Figure 8.27 Remove the knob and lock nut from the speed
control. Install speed control onto access panel with stem
sticking out the pre-punched hole. Attach the lock nut
tightly and re-attach the knob on the stem.
Attach blue and black wires routed through orange
grommet in fan housing to the speed control. Re-install
access panel.
3
LOCK NUT
AND STEM