Glass Replacement - Heat & Glo TIARAII-BK-B Owner's Manual

BLACK
TEMPERATURE SENSOR SWITCH
Figure 8.28
K. Glass Replacement
1. Turn appliance OFF and let cool down before replac-
ing the glass.
2. Remove the front by lifting upwards 1/2 in. (13mm)
and away from the appliance.
3 Remove the glass door by opening the latches located
on both the left and right sides at the top of the glass.
Pull towards you and separate latches from notches.
Lift the glass out of the two notches at its bottom and
carefully set aside.
4. The new glass will come installed in a new glass frame.
Installation of the new glass and frame is the opposite
of the removal.
5.
Re-install appliance front.
VARIABLE SPEED CONTROL
JUNCTION BOX
BLACK
GROUND
BLACK
110 - 120 VAC
POWER SUPPLY
Heat & Glo • TIARA II-B • 7011-148 Rev. D • 12/11
WHITE
GREEN
Handle glass assembly with care.
• Inspect the gasket to ensure it is undamaged.
• Inspect the glass for cracks, chips or
scratches.
• Do NOT strike, slam or scratch glass.
• Do NOT operate appliance with glass door
removed, cracked, broken or scratched.
• Replace glass assembly as a complete
assembly.
BLOWER RECEPTACLE
BLOWER
CAUTION
33