Installation Standard Work Checklist - Heat & Glo MEZZO48-B Installation Manual

Owner's manual (22 pages)

Table of Contents

Installation Standard Work Checklist

This standard work checklist is to be used by the installer in conjunction with, not instead of, the instructions contained in this

installation manual.

Customer:

Lot/Address:

Model

(circle one):

MEZZO36-B MEZZO48-B MEZZO60-B MEZZO72-B

MEZZO36ST-B MEZZO48ST-B MEZZO60ST-B MEZZO72ST-B

WARNING! Risk of Fire or Explosion! Failure to install appliance according to these instructions can

lead to a  re or explosion.

Appliance Install Sections 3 and 6

Veri ed that the chase is insulated and sealed. (Pg. 20)

Required factory included non-combustible board is installed. (Pg 36)

Standoffs bent up into installation position and secured. (Pg. 34)

Veri ed clearances to combustibles. (Pg. 16-19)

Fireplace is leveled and secured. (Pg. 35)

Pipe heat shield is bent up and attached to header. Header no wider than

3.5 in.(2x4) (Pg. 18, 19, 34)

Venting/Chimney Sections 4,5 and 7

Venting con guration complies to vent diagrams. (Pg 23-30)

Venting installed, locked, and secured in place with proper clearance.

Firestops installed. (Section 5)

Attic insulation shield installed. (Pg 32)

Exterior wall/Roof  ashing installed and sealed. (Section 7)

Terminations installed and sealed. (Section 7)

Electrical Section 8 (Pg 43-44)

Unswitched power (110-120 VAC) provided to the appliance.

Switch wires properly installed.

Gas Section 9 (Pg 45-48)

Proper appliance for fuel type.

Was a conversion performed?

Leak check performed and inlet pressure veri ed.

Veri ed proper air shutter setting for installation type.

Finishing Section 10 (Pg 49-59)

Combustible materials not installed in non-combustible areas.

Veri ed all clearances meet installation manual requirements.

Finishing done correctly using inside  t or overlap  t method.

Bottom  nishing template and  nishing guards removed.

Mantels and wall projections comply with installation manual requirements.

Appliance Setup Section 11 (Pg 60-62)

All packaging and protective materials removed (inside & outside of appliance).

Refractories and media installed correctly.

Glass assembly installed and secured.

Accessories installed properly.

Decorative front properly installed.

Manual bag and all of its contents are removed from inside/under

the appliance and given to party responsible for use and operation.

Started appliance and veri ed no gas leaks exist.

Lights work in all switched positions (if so equipped).

Component heat shield is installed. (Pg. 43.)

Hearth & Home Technologies recommends the following:

• Photographing the installation and copying this checklist for your  le.

• That this checklist remain visible at all times on the appliance until the installation is complete.

Comments: Further description of the issues, who is responsible (Installer/ Builder/ Other Trades, etc) and corrective

action needed _____________________________________________________________________________________

Comments Communicated to party responsible ____________________ by ______________________on ___________

 = Contains updated information.

Heat & Glo • MEZZO36-B/ST-B, MEZZO48-B/ST-B, MEZZO60-B/ST-B, MEZZO72-B/ST-B Installation Manual • 2300-973 Rev. R • 12/18

ATTENTION INSTALLER:

Follow this Standard Work Checklist

(Builder / Gen. Contractor/) (Installer)

Date Installed:

Location of Fireplace:

Installer:

Dealer/Distributor Phone #

Serial #:

YES

IF NO, WHY?

___________________________

(Date)

2300-975 Rev. B 4/17

Table of Contents

This manual is also suitable for:

Mezzo36st-b Mezzo36-b Mezzo48st-b Mezzo60-b Mezzo60st-b Mezzo72-b ... Show all

Installation Standard Work Checklist - Heat & Glo MEZZO48-B Installation Manual