Mesh Fronts - Heat & Glo RED40 Owner's Manual

E. Mesh Fronts
WARNING! Risk of Burns! A decorative front is required
for this model. DO NOT operate this appliance without a
decorative front in place.
Only doors certifi ed for use with this appliance model may
be used. Contact your dealer for a list of doors that may
be used.
A mesh front is included with the RED40 and RED40ST.
To attach the mesh front to the appliance, use the two
mesh brackets. These brackets are mounted to the un-
derside of the top of the appliance viewing area and are
fastened to the appliance by two screws on each bracket.
See Figure 13.15. There are two hanging tabs on the
back of the mesh front assembly that are bent upward.
Engage these tabs in the slot of the brackets.
MESH FRAME
ASSEMBLY
HANGING TABS
MESH BRACKETS
MESH FRAME ASSEMBLY
Figure 13.15. Mesh Front Installation.
58 Heat & Glo • RED40, RED40ST • 2155-900 Rev. F • 8/09