Setup; Ac Power; Ac Plug; Power Linking - Chauvet COLORado 1 IP User Manual

3. Setup

AC Power

AC Plug

Power Linking

COLORado™ 1 IP User Manual Rev. 2
The COLORado™ 1 IP has an auto-ranging power supply that works with an input voltage
range of 100~240 VAC, 50/60 Hz.
Make sure that you are connecting this product to the proper voltage. To determine the
power requirements for the COLORado™ 1 IP, refer to the specification label affixed to the
product or the specifications in this manual.
Refer to the Technical Specifications
Always connect this product to a protected circuit with an appropriate electrical
ground to avoid the risk of electrocution or fire.
The listed current rating indicates the maximum current draw during normal operation. For
more information, download the document Sizing Circuit Breakers from the CHAUVET®
website: www.chauvetpro.com.
Never connect this product to a rheostat (variable resistor) or dimmer circuit, even if
the rheostat or dimmer channel serves only as a 0% to 100% switch.
The COLORado™ 1 IP comes with IP66 rated cords for Power In and Power Out with
proprietary IP66 connectors. These power cords access the sealed body of the fixture
through IP66 cable glands. To allow connection to power outlets, the fixture comes with a
power input cord with a proprietary IP66 connector on one end and an Edison plug on the
other end (US market). If the power input cord that came with your product has no plug, or
if you need to change the Edison plug, use the table below to wire the new plug.
Connection Wire (U.S.)
AC Live Black
AC Neutral White
AC Ground Green/Yellow
The COLORado™ 1 IP supports power linking. You can power link up to 12 products at
120 VAC or 24 at 230 VAC.
This product comes with a power input cord and an IP66 power linking cord to allow direct
connection between fixtures.
chart.
Wire (Europe) IP66 Pin
Brown 1
Blue 2
Green/Yellow 3
Setup
Screw Color
Yellow or Brass
Silver
Green
-5-