Mounting; Orientation; Rigging - Chauvet COLORado 1 IP User Manual

Mounting

Orientation

Rigging

Procedure
Product Mounting
Diagram
COLORado™ 1 IP User Manual Rev. 2
Before mounting this product, read and follow the
Always mount this product in a safe position and make sure there is adequate room for
ventilation, configuration, and maintenance.
The COLORado™ 1 IP consists of a sealed (IP66) housing with a double bracket mounting
yoke. It has two DMX signal cables (DMX In/DMX Out), and two power cables (Power
In/Power Out), all of them fitted with proprietary IP66 connectors. CHAUVET®
recommends using the following general guidelines when mounting this product.
• When selecting an installation location, consider easy access to this product for
operation, programming adjustments, and routine maintenance.
• Make sure to mount this product away from any flammable material as indicated in the
Safety Notes.
• Never mount in places where rain, high humidity, extreme temperature changes, or
restricted ventilation may affect the product.
• If hanging this product, make sure that the mounting location can support the product's
weight. Refer to the
of this product.
• When hanging this product, always secure to a fastening device using a safety cable
(included).
The COLORado™ 1 IP comes with double bracketed mounting yoke to which you can
attach clamps. These brackets also serve as floor stands or wall-mount supports. You
must supply your own clamps and make sure the clamps are capable of supporting the
weight of this product.
Overhead Mounting
Technical Specifications
Safety Notes in this manual.
chart for the weight-bearing requirements
Floor Mounting
Setup
-7-