Installation - Jensen JIMS-285 Owner's Manual

FOR TABLE TOP USE
The stand is attached to the main unit for table top use as figure 1a below. You can also attach the
speaker boxes to the main unit as figure 1b shown below.
Fig. 1a
CAUTION: Use a screwdriver to tighten all speaker hanger screws (included) to avoid accidental
falling before mounting speaker boxes to the main unit.
FOR WALL MOUNTING
1) Remove the speaker boxes and the stand from the main unit.
2) Use the wall-mounting template supplied with the unit to make anchor hole marks on the wall.
Make sure the marks are level before drilling.
3) Drill 1/4" holes on the marks.
4) Insert the included plastic anchors into the holes and push in until they are flush with the wall.
5) Insert the included screws into the anchors and tighten until the screw head is about 6.5mm
away from the wall. Line up the slots located on the back of the main unit and speakers with the
screws in the wall. See illustration below.
NOTE: This unit is not magnetically shielded and may cause color distortion on the screen of some
TVs or video monitors. To avoid this, you may need to move the unit further away from the TV or
monitor if unnatural color shifts or image distortion occurs.

INSTALLATION

7
Fig.1b