Table of Contents
Advertisement
To receive a weak (noisy) FM station, press the ST/MO button to switch the FM mode to
2.
"MONO". The reception may be improved, but the sound is now monaural (MONO).
Note:
1. When listening to an FM program, fully extend the Wire Antenna to insure maximum tuner
sensitivity.
2. The AM receiver uses an external AM loop antenna. If the AM reception is weak, slightly
rotating or re-positioning the loop antenna will usually improve the AM reception.
3. Automatic tuning depends on the signal strength of the broadcasting station, so week
stations may be skipped. You can manually tune to find the week stations if a station gets
skipped. With strong signals, the tuner may stop before it reaches the actual broadcast
frequency, so you may need to manually tune for the best reception.
PRESET STATIONS (USING REMOTE CONTROL)
This unit is equipped with preset memories for AM and FM.
radio stations in the memory.
1. Press the POWER
2. Press the FUNCTION button to select TUNER mode.
3. Tune to the desired radio station either "manually" or using the "auto" tuning method.
4. Press the "MEM/CLK-ADJ" button to enable the program function and the "MEM" indicator will
show on the LCD. Preset channel number "1" is flashing.
5. Press the FOLDER / PRE
desired preset channel.
6. Press the MEM/CLK-ADJ button again to confirm the setting.
7. Repeat steps 3 to 6 to store other stations if necessary.
RECALLING THE PRESET STATIONS
1.
Press the POWER
2.
Press the FUNCTION Button to switch to the radio mode.
3.
Press the "FOLDER/REP -UP" button on the main unit or " FOLDER / PRE
on remote control to select the preset channels.
Note:
1. There is a 10 second delay when programming, after 10 seconds, the unit will automatically
switch back to normal tuner mode.
2. You can overwrite a present station by overwriting and storing the new frequency in its place.
NOTE: This player will not only play commercial CDs, but also self-complied CD-D/RW discs.
Do not attempt to play CD-ROM, CDI, VCD, DVD or computer CDs.
Notes on CD-R/RW Discs
•
Because of non-standardized format definition/production of CD-R/RW/MP3/WMA-CD,
playback quality & performance are not guaranteed.
•
Manufacturer is not responsible for the playability of CD-R/RW/MP3/WMA-CD due to
recording conditions such as PC performance, writing software, media ability, etc.
•
Do not attach a label or seal to either side of the CD-R/RW/MP3/WMA disc. It may cause a
malfunction.
The following procedures can be accomplished by using the remote or controls on the unit.
button to turn on the unit.
or
button to select the
Button to turn on the unit.
CD OPERATIONS
You can store up to 10AM + 10FM
12
or
" button
Advertisement
Table of Contents
