Auxiliary Input - Jensen JIMS-285 Owner's Manual

Wake to Radio / CD / iPod
• When the alarm time is reached, the selected alarm source Radio, CD or iPod will automatically
turn "ON" and play for 60 minutes then shut off and reset itself for the following day (without
pressing the snooze button).
• During the activation of the desired alarm source, you may press the SNOOZE button to activate
the snooze function. The alarm source stops for the snooze time (10 minutes) then comes again.
The snooze operation can be repeated again within the remaining 50 minutes from the set alarm
time.
• To stop the alarm immediately after the alarm source sounds, press the ALARM 1 button once. It
resets itself for the following day.
. To cancel the following day alarm, press the ALARM 1 button once again, ALARM 1 icon will
go off.
C. SNOOZE FUNCTION
Press the SNOOZE button once to terminate the wake alarm temporarily, and the alarm will re-start
again after 10 minutes. To cancel the SNOOZE mode, press the POWER Button once.
SNOOZE icon will disappear from display and alarm icon stop flashing.
MUTE FUNCTION (REMOTE CONTROL ONLY)
- Press the MUTE button on remote control to mute the sound output from speaker temporarily,
"MUTE" will appears on display and flashing.
- Press the MUTE button again to resume to normal speaker playback.
PRESET EQ (REMOTE CONTROL ONLY)
This unit provides 5 differences sound mode to enhance your listening experience. You can select
the desired effect by pressing the " PRESET EQ" button on remote control repeatedly at following
sequence:
FLAT CLASSIC ROCK POP JAZZ

AUXILIARY INPUT

This unit provides an auxiliary audio signal input jack for connecting external audio devices like
MP3 players, CD players and older, non-dockable iPods and listen to your external source through
the speakers of this system.
1. Use an audio cable (not included) with one 3.5 mm stereo plug on each end of the cable.
2. Plug one end into the Aux-in jack on the main unit and the other end of the cable into the
Line-out Jack or Headphone Jack of your external audio device.
3. Turn on the external audio device.
4. To select auxiliary audio input, press the FUNCTION button to select "AUX" mode.
5. The volume level can now be controlled through the main unit. Operate all other functions on the
auxiliary device as usual.
18