Display Assembly Components (Cable, Antennas, Hinges, Enclosure) - HP EliteBook 8460w Maintenance And Service Manual

Display assembly components (cable, antennas, hinges, enclosure)

This section describes removing components that require you to completely remove the display
panel. For more information about removing display components that do not require that you remove
the assembly from the computer, see
microphone) on page
All display assemblies include WLAN antenna transceivers and cables. WWAN models include 2
WWAN antenna transceivers and cables.
For a list of display spare parts, see
Before removing the display assembly, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet,
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the following components:
a. Remove the bottom door (see
b. Hard drive (see
c. Optical drive (see
d. WLAN module (see
e. WWAN module (see
f. Fan (see
g. Heat sink (see
h. Modem module (see
i. Keyboard (see
j. Bottom cover (see
Remove the display assembly:
1. Position the computer right-side up with the front toward you.
110 Chapter 4 Removal and replacement procedures
Display assembly components (panel, bezel, webcam,
65.
Display components on page
Battery on page
Bottom door on page
Hard drive on page
Optical drive on page
WLAN module on page
WWAN module on page
Fan on page 90)
Heat sink on page
Modem module on page
Keyboard on page
Bottom cover on page
36.
63).
70).
76)
72)
83)
81)
91)
89)
96)
98)