Adjustments - Blodgett COMBI COS-20G Installation And Operation Manual

BEFORE SWITCHING THE APPLIANCE ON
Before applying power to the unit for the first time,
check for the following conditions:
The unit is level.
j
All electrical safety provisions have been ad-
j
hered to and the electrical connections are
correct.
The circulation blower wheels should turn
j
counter-clockwise: check rotation from inside
the oven cavity.
Water is connected, turned on and all of the
j
connections are water tight.
Check gas fittings with leak detection solution.
j
The transport cart is inserted into the cooking
j
cavity. When the cart is not inserted into the unit,
water can spill onto the floor causing it to be-
come slippery. If the door will not close properly,
use the
NOTE: The first time the unit is turned on, or after
the unit has been OFF for 5 hours and then
turned on, it will automatically flush the
steam generator for a period of 75 sec-
onds. The steam generator will then fill to
the proper water level. The unit is now
ready for operation.
DOOR ADJUSTMENT
The hinges may be adjusted using the following
procedure:
1. Adjust the top hinge plate by loosening the
2. Adjust the bottom hinge pin by loosening the
3. Adjust the hinges so that the door back and
4. Tighten the bolts so that there is no further
5. The adjustment is correct when the door
The hinges can also be adjusted as follows:
1. Adjust the door catch by loosening the four
2. The adjustment is correct when no steam
COS-20G
Figure 4
9
Installation
three mounting bolts on the top right corner of
the unit.
mounting bolt located under the bottom hinge
plate on the lower right corner of the oven.
the unit face are parallel.
movement.
closes firmly and no steam leaks from the gas-
ket.
mounting screws located on the inside sur-
face of the oven door.
leaks from the gasket.
Oven
Door
Oven
Door

Adjustments