Invacare top end terminator series User Manual page 56

®
Top End Terminator™Series
– Adjustable Camber System Only - Make sure the
notches in the axle tube B are towards the rear
of the wheelchair and the slots in the axle tube B
are facing up.
10. Adjustable Camber System Only - Install the adjustment rings
E onto the new axle tube B. Make sure the stops on the
adjustment rings E are facing towards the outside of the
wheelchair.
– Do not tighten the Phillips screws D that secure
the adjustment rings E to the axle tube B at this
time.
11. Slide the new axle tube B through the other camber clamp
C until the axle tube B is evenly spaced between the camber
clamps C.
– Do not close the camber clamps Cat this time.
WARNING!
– NEVER position the camber inserts A in the axle
tube B with more than 3 inches (7.62 cm) (12
indexing marks showing) of the camber insert A
outside of the axle tube B. The camber inserts
A will not be securely tightened in the axle tube
B. Possible injury to the user or damage to the
wheelchair may occur.
12. Adjustable Camber System Only - Install camber inserts A into
the new axle tube B and slide the camber inserts A to the
position noted in STEP 1. Make sure there are no more than 3
inches (12 indexing marks) of the camber inserts A outside of
the axle tube B.
56
13. Adjustable Camber System Only - Slide the indexing ring F on
the camber insert A until it is flush with the camber clamp C.
– To maximize rollability: Before using the
wheelchair, make sure both camber inserts A are
set to the same indexing notch. This will make
sure the distance between the rear wheel and the
wheelchair is the same on both sides.
14. Install the rear wheels onto the wheelchair.
15. Adjust the axle tube B.
– The performance of the wheelchair will be affected if
the toe in/toe out of the wheelchair is not correct.
– Suspension option not shown for clarity. Axle tube B
installs in the same manner as pictured above.
1171801-A