Service; Removing/Installing Foldover Back Upholstery; Installing The Swingaway Padded Armrest; Socket - Invacare top end terminator series User Manual

®
Top End Terminator™Series

5 Service

5.1 Removing/Installing Foldover Back Upholstery

Removing
1. Unfasten the two fastening flaps A that secure the bottom of the
existing back upholstery B to the back posts C.
2. Unfold the top of the back upholstery B.
Lift up on the existing back upholstery B and remove from the
3.
wheelchair.
Installing
Install the new back upholstery B onto the back posts C.
1.
2. Wrap the end of a fastening flap A around the back post C.
Insert the end of the fastening flap A through the loop D.
3.
4. Wrap the fastening flap A around the back post C again and
press firmly to secure.
5. Fold the top of the back upholstery B down over the back posts
C towards the front of the wheelchair.
6. Press firmly to secure the fastening strips E.
48

5.2 Installing the Swingaway Padded Armrest

Socket

WARNING!
– After any adjustments, repair or service and before
use, make sure all attaching hardware is tightened
securely - otherwise injury or damage may occur.
– Do not attempt to lift or tilt a wheelchair by using
any removable (detachable) parts. Lifting by means
of any removable (detachable) parts of a wheelchair
may result in injury to the user or damage to the
wheelchair.
1171801-A